Home
1
Hot News
2
Application articles / Other
3
Basement parking LED lighting options? [LED T8 Radar Tube] [LED tube Microwave control]4
https://www.prodigital.com.tw/en/ Prodigital Technology Corp.
Prodigital Technology Corp. 12F, No.358 Chung Hwa road, Chu pei city, Hsin chu county, Taiwan R.O.C.
This time we introduce the performance of fully-filled LED soft strip lights. The original LED step lights used sleeved LED soft strip lights and LED glue strip lights. These two models are known in the industry as having an IP65 rating, but this approach is not recommended for use in outdoor engineering cases or LED landscape cases. Difference description: A.LED sleeve soft strip lights are actually composed of bare board + silicone sleeve, achieving dustproof and waterproof. 1. When the LED is hit by a frontal impact, the silicone sleeve is soft and does not protect the internal LED. 2. The inlet end of the casing must be properly protected to avoid water intrusion due to pulling and rupture after construction. 3. When the waterproofing of the on-site wiring is poor, water or moisture will penetrate the copper wire's cooling and heating effects, causing siphonage and water intrusion. B. LED glue strip lights are covered with a layer of PU glue on the exposed LED board to achieve dustproof and waterproof on the front. 1. The main disadvantage of the LED flexible strip light is that the back is not waterproof Outdoor lighting mainly depends on the quality of the product itself + the quality of on-site construction to extend its service life. Factory customization Recommended length: DC24V length 20 meters double-ended power supply, DC12V length 10 meters double-ended power supply Color temperature range: 2700K ~ 6500K Power range: 5W ~15W/meter, single row Waterproof level: IP68 Outlet method: 2 wire length < 10 meters Leave a waterproof layer on the front and back of the PCBA LED soft board, and tightly cover the LED and soft board. The wires are also wrapped in adhesive material, and the outer layer has a heat-shrinkable sleeve to enhance waterproofing and reduce the pulling force that may cause the adhesive material to break. After learning about the product, go to the construction site to see actual performance. Removing glue from lamp power wiring hole cover Clear the original LED glue strip lights and LED tube soft strip lights operations, Site bonding requires silicone to reinforce waterproofing Use a scraper to remove it and it will almost become crispy! Removing old silicone takes a lot of time!! Take out the arrangement position of LED soft strip lights Peel off the 3M adhesive on the back and press along the edges to fix it! After pressing, apply glue to the power hole. The 3M adhesive tape is only for temporary fixation. In actuality, the upper and lower edges of the LED flexible strip lights and the joints with the wall must be firmly covered with a layer of glue to prevent them from falling off. Fixed completed appearance Actual effect at night   LED soft strip light products https://www.prodigital.com.tw/en/product_cg257608.html Introduction to various types of LED soft strip lights  https://www.prodigital.com.tw/en/hot_362663.html https://www.prodigital.com.tw/en/hot_471661.html Taiwan Hsinchu Community Landscape LED Step Light LED Outdoor Full Glue-filled Soft Strip Light Construction Case 2024-04-19 2025-04-19
Prodigital Technology Corp. 12F, No.358 Chung Hwa road, Chu pei city, Hsin chu county, Taiwan R.O.C. https://www.prodigital.com.tw/en/hot_471661.html
Prodigital Technology Corp. 12F, No.358 Chung Hwa road, Chu pei city, Hsin chu county, Taiwan R.O.C. https://www.prodigital.com.tw/en/hot_471661.html
https://schema.org/EventMovedOnline https://schema.org/OfflineEventAttendanceMode
2024-04-19 http://schema.org/InStock TWD 0 https://www.prodigital.com.tw/en/hot_471661.html

Introduce a product that is most suitable for parking lot lighting,
radar (microwave) automatic sensor tube / LED T8 Radar Tube
(Free change circuit / system Free / Low maintenance / longevity / highest energy)
LED radar sensor lamp manufacturer

Parking lot lighting is 24 hours use, choose high efficiency with sensor light selection
Making the car park lighting can save 85%~90% electricity.

LED radar sensor lamp manufacturer

There is no need to invest in the cost of system setup, not to adjust the circuit, and the maintenance cost is very low and easy in the future.

Therefore, the basement parking lot is adopted, so that the reduction of electric power can also enhance the lighting quality of the parking lot.

Under the same conditions to provide better options, it is particularly recommended LEDT8 radar sensor lamp,
Immediately improve the reduction of electricity prices and get rid of the problems of setting up the system, which can improve the lamp life and reduce the maintenance cycle.

Example: Infrared sensor PIR control lamps, from the original control of the indoor staircase lights, corridor lights, etc.,

The majority of incandescent lamps are used, and the control is more convenient. There are also fluorescent lamps, but the life is greatly reduced and the stroboflash phenomenon is also serious.

Along with the phase-out of incandescent lamps and the popularization and application of LED light sources, it brings an extremely wide range of applications to infrared sensors.
The cost of lighting control is gradually reduced, the cost performance is continuously improved, and the energy-saving effect is more obvious.

Infrared Sensor Introduction - Works through infrared radiation emitted by the human body.
The infrared radiation emitted by the human body is enhanced by the Fresnel filter lens and accumulated on the pyroelectric element. When the human body is active, the infrared radiation is

Changes in the firing position cause the device to lose its electrical balance and convert it into an electrical signal, ie thermoelectric conversion.

The normal temperature of the human body is about 36 degrees, and the far-infrared peak emitted is 9.4 meters. By detecting body surface temperature and ambient temperature

The difference in the degree of change, the resulting electrical signal, to determine whether someone is active and output the signal. There are many types of infrared sensors, applications

Also widely used, there are many types of sensor element performance and lens design, generally divided into large area type and small area type.

In recent years, miniature sensors have been developed to be installed in lighting fixtures, such as garage lamp series, staircase lamp series, and hotel customer lighting series.

Infrared sensors have been widely used due to their relatively low prices and generally do not require adjustments.

When designing a lamp, its characteristics and use environment should be grasped, sensors should be applied correctly, and efforts should be made to reduce the cost of the lamp.

Radar sensor introduction - Radar (microwave) sensor application.
LED radar sensor lamp manufacturer
Example: Automatic glass door sensors use radar sensors
There are many cases and the history is very long. In the early stage, it was widely used in military, shipping, automotive, level measurement, and life exploration.

Product performance is stable and reliable. The distance of action is related to the pulse width and the vertical width of the beam, such as the pulse width of 0.01 microseconds, the distance

Resolving power is about 25M. Radar is a device that detects and measures target information by emitting electromagnetic waves and echoes.

This feature enables the independent control of the lamps to achieve the most efficient energy saving.

Comparison of advantages and disadvantages

Features

Human sensing infrared type (PIR)

Radar (Microwave) Type 3.6G

Sensing distance

Within 5 meters

Within 13 meters

Sensing range

10m²-20m²

20m²-40m²

Conditions of Use

Limit the scope of use

Wide range of use

Advantages

Low power, low price

Low power, high sensitivity,
no blind area

Shortcomings

Easily interfered by various heat sources, poor penetration,
blind area

Used in low flow areas,
prices are slightly higher

lifespan

4 year

8 year

Product Specifications:(LED T8 Radar Tube) 

Apply Movie:
https://youtu.be/y-Ue8qtkvws
https://youtu.be/h7B29KblvyM
https://youtu.be/jKKH0jWbsFU
https://youtu.be/TeQfZGUhsSU
https://youtu.be/HNs6DDtz_HU
https://youtu.be/gz68GCDJIxI
https://youtu.be/m62oJUlaNbE

0df17b1354436c22c4da0f8c73d52a7d.png

Previous Back to List Next